Logging diagnostic data

Introduction

The diagnostic check generates information for immediate use, The results are shown but not saved. To see the results again, you must run the data processing again. To save the data returned by the diagnostic, you must activate a log results function, which generates a log.

This function is only available for the original scenarios and is activated by process by the validation rules () according to the following criteria:

If...	Then...
Enable detected errors trace = Don't manage	the errors detected by the diagnostic check will not be logged.
Enable detected errors trace = Only manage for blocking signals	only errors with Blocking severity will be logged.
Enable detected errors trace = Manage the table for all signals	all the errors detected by the diagnostic check will be logged.

If the log function is active, the data in the log is updated on every submission or running of the diagnostic checks where the Update log option is selected.